 |
Remove |
|
|
 |
Risk of accident
caused by vehicle starting off by itself when engine is running. Risk of injury
caused by contusions and burns during starting procedure or when working near engine |
Secure vehicle to prevent it from moving.
Wear closed and snug-fitting work clothes.
Do not grasp hot or rotating parts. |
AS00.00-Z-0005-01A |
| 1 |
Park vehicle on a horizontal surface. |
|
|
| 2 |
Open engine hood |
Model 203 |
AR88.40-P-1000P |
| |
|
Model 209 |
AR88.40-P-1000Q |
| 3 |
Break plate (93b) off locking pin (93a) using a suitable tool |
|
|
| 4 |
Press out pin remaining in the cap (93) downwards |
|
|
| 5 |
Take off cap (93) |
|
|
| 6 |
Fill with transmission oil |
When first filling or after an oil change, add only approx. 5 l of transmission oil
before starting the engine. |
|
| |
|
 |
*BF27.00-P-1001-01C |
| |
|
Funnel |
Fig 2 |
| |
|
Filling pipe |
Fig 5 |
| 7 |
Start engine and allow to idle in selector lever position" P" |
|
|
| 8 |
Top up with the rest of the specified quantity of oil |
When first filling or after an oil change. |
|
| 9 |
Shift through the driving stages several times with the vehicle stationary and the engine idling |
Operate service brake! |
|
| 10 |
Read off transmission oil temperature |
Apply service brake. Move selector lever to position "R" or "D". |
|
 |
Connect STAR DIAGNOSIS and read out fault memory |
|
AD00.00-P-2000-04A |
| |
|
STAR DIAGNOSIS diagnosis system |
*WH58.30-Z-1048-13A |
 |
Check |
|
|
| 11 |
Inspect transmission oil level |
Move selector lever to position "P". Insert oil dipstick up to the stop, pull out, read off oil level, repeat if necessary. The correct oil level should be measured at a transmission oil temperature of 80°C. |
|
| |
|
At a transmission oil temperature of 25°C, the fluid level must be within the range "A". At a transmission oil temperature of 80°C, the oil level must be within the range "B". |
|
| |
|
Measuring rod |
Fig 3 |
| 12 |
Warm up transmission |
Once a transmission oil temperature of 80°C has been reached, wait for at least two minutes. |
|
| 13 |
Move selector lever to position "R" or "D" |
Operate service brake! |
|
| 14 |
Inspect transmission oil level |
Shift selector lever into position "P". |
|
| 15 |
Correct transmission oil level |
It is essential to drain off or suction off an excess fill of transmission oil! An insufficient or excessive oil quantity causes malfunctions and transmission damage. |
|
| |
|
Hand pump |
Fig 4 |
| 16 |
Check transmission for leaks |
If there is a loss of oil, determine and eliminate the cause. An insufficient or excessive oil quantity causes malfunctions and transmission damage. |
|
 |
Install |
|
|
| 17 |
Fit cap (93) on oil filler pipe. |
|
|
| 18 |
Press in new locking pin (93a) |
The locking pin (93a) must lock in place. |
|