Removing/installing air cleaner housing - AR09.10-P-1150AC

ENGINE 113.988 in MODELS 203.076 /276 

ENGINE 113.987 in MODELS 209.376 /476 as of 24.4.04 

ENGINE 113.989 in MODEL 171.473 

Shown on model 203.276 

Fig 1: Identifying Air Cleaner Housing Remove/Install Components - Shown On Model 203.276

	Removal/installation
	Risk of injury  caused by fingers being jammed or pinched  when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	When moving components, ensure that no body parts or limbs are within the operating range of moving parts.	AS00.00-Z-0011-01A
1	Open engine hood	MODEL 203	AR88.40-P-1000P
		MODEL 209	AR88.40-P-1000Q
		MODEL 171	AR88.40-P-1000V
2	Remove engine intake air ducts (3)	On left and right.
3	Remove front trim (1)
4	Lift off air cleaner housing (2) with intake line from engine	Removal: Detach air cleaner housing (2) vertically toward the top from the cylinder head covers. Installation:  Slightly moisten the rubber retainers (4) on the cylinder head covers and the sealing ring of the hot film mass air flow sensor (B2/5) in the air cleaner housing (2) with sliding compound.
		Lubricant	*BR00.45-Z-1002-06A
5	Install in reverse order