Retrofitting ultrasonic backup assist - AZ54.65-P-0001J: Notes
MODEL 220.0 /1 up to 30.6.02 except CODE (550) Trailer hitch
| Removing | |||
| Risk of explosion from electrolytic gas. Risk of poisoning and caustic burns from swallowing battery electrolyte. Risk of injury with caustic burns to eyes and skin from battery electrolyte or from handling damaged lead acid batteries | No fire, sparks, naked flames or smoking. Wear acid-resistant gloves, clothing and eye protection. Pour battery electrolyte only into suitable and appropriately marked containers. |
AS54.10-Z-0001-01A | |
| 1 | Disconnect ground lead from battery | ||
| AR54.10-P-0003I | |||
| Notes on battery | All models | AH54.10-P-0001-01A | |
| Notes on AGM battery | Only if installed: MODEL 220.028 with CODE (450) Taxi version MODEL 220.070 /075 /175 /178 /875 /878 as of 1.1.01. |
AH54.10-P-0002-01A | |
| 2 | Remove rear bumper | ||
| AR88.20-P-2200M | |||
| 3 | Remove impact absorber from bumper | ||
| 4 | Remove trim panel in trunk | Right trim panel. | |
| Model 220.026 /028 /063 /065 /070 /073 /075 /128 /165 /170 /173 /175 /178 /875 /878. | AR68.30-P-4600M | ||
| 5 | Remove paneling on C-pillar | Right C-pillar. | |
| AR68.30-P-4490M | |||
| Installing | |||
| 6 | Paint sensors and contour rings | AZ54.65-P-0001-01A | |
| 7 | Drill holes in bumper | AZ54.65-P-0001-02I | |
| 8 | Install and connect sensors | AZ54.65-P-0001-03A | |
| 9 | Install impact absorber in bumper | ||
| 10 | Install rear bumper | ||
| AR88.20-P-2200M | |||
| 11 | Install control module | AZ54.65-P-0001-04J | |
| 12 | Install display instrument | AZ54.65-P-0001-05K | |
| 13 | Route and connect wiring harness | AZ54.65-P-0001-06A | |
| 14 | Install paneling on C-pillar | ||
| AR68.30-P-4490M | |||
| 15 | Install trim panel in trunk | ||
| Model 220.026 /028 /063 /065 /070 /073 /075 /128 /165 /170 /173 /175 /178 /875 /878. | AR68.30-P-4600M | ||
| 16 | Connect ground lead to battery | ||
| AR54.10-P-0003I | |||
| 17 | Check ultrasonic backup assist | AZ54.65-P-0001-07A | |
| 18 | Hand the manufacturer's safety/operating instructions to the customer when returning the vehicle |
PARTS ORDERING NOTES
| Part no. | Designation | Quantity |
|---|---|---|
| B6 782 3401 | Universal basic kit | 1 |
| B6 782 3402 | Vehicle kit W/V 220 and W/S 202 | 1 |