Remove/install thrust arm - AR35.20-P-0113I

MODEL 215.373 /374 /375 /376 /378 /379, 220.025 /026 /028 /063 /065 /067 /070 /073 /074 /075 /083 /084 /087 /125 /126 /128 /165 /167 /170 /173 /174 /175 /176 /178 /179 /183 /184 /187 

Shown on model 220 with Airmatic 

Fig 1: Identifying Thrust Arm Remove/Install Components - Shown On Model 220 With Airmatic

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates below the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the parts will be affected
	Notes on self-locking nuts and bolts	All models	AH00.00-N-0001-01A
1	Raise vehicle
2	Unclip thrust arm cover (5g).
3	Detach thrust arm (5) from wheel carrier and rear axle carrier	Installation:  When tightening the camber strut the vehicle must be relieved of load and on its wheels. Otherwise the rubber mounts are constantly under preload and are damaged as a result.
		Self-locking nut, thrust arm to rear axle carrier	*BA35.20-P-1001-05A
		Model 215 except 215.376 /379, 220 except 220.074 /174 /176 /179: ↓
		Self-locking nut, thrust arm to wheel carrier.	*BA35.20-P-1003-05A
		Screwdriver bit	*119589001000
		Models 215.376 /379, 220.074 /174 /176 /179: ↓
		Bolt, thrust arm to wheel carrier	*BA35.20-P-1004-05A
4	Install in the reverse order

TORQUE STRUT

TORQUE STRUT

Fig 2: Identifying Screwdriver Bit (119 589 00 10 00)