Closing sliding /pop-up roof, function - GF77.20-P-2002GH

MODEL 163 with CODE (414a) Electric glass sliding/pop-up roof 

Function prerequisites 

• Voltage not too low or too high
• Switch-on conditions for convenience control fulfilled

Function 

The sliding roof and pop-up roof can be closed by pressing the switch (SR, S13/2)  . The sliding/pop-up roof can only be closed by continuously pressing the switch (SR, S13/2)  .

The express close function is not available for safety reasons.

If the sliding/pop-up roof has not been synchronized, it opens only in the pop-up roof direction each time the switch (SR, S13/2)  is actuated. Upon reaching its end position, i.e. before the pop-up roof is completely open, synchronization  is accomplished.

After successful synchronization, the sliding/pop-up roof can then be controlled without limitations.

Vehicles up to 11.99: 

The power for the sliding/pop-up roof (M12)  is supplied via a fuse directly to c. 30.

The power for the switch (SR, S13/2)  is supplied via the convenience relay (F1k14)  , which is actuated by the all-activity module (AAM, N10) 

Vehicles as of 12.99: 

The power for the sliding/pop-up roof (M12)  is supplied via a fuse directly to c. 30. The power for the switch (SHD, S13/2)  is supplied via a lead to the extended-activity module (EAM, N10/1)  , this power is switched through only when the switch-on conditions for the convenience control are fulfilled and the EAM is coded accordingly.

	Opening pop-up roof, function		GF77.20-P-2003GH
	Opening sliding roof, function		GF77.20-P-2004GH
	Synchronizing sliding /pop-up roof, function		GF77.20-P-3002GH
	Sliding/pop-up roof, location/purpose/ design/ function		GF77.20-P-4100GH
	Convenience control		GF72.29-P-2002GH
	All-activity module (AAM)	up to 11.99	GF54.21-P-4100GH
	Extended-activity module, location/ purpose/ design	as of 12.99	GF54.21-P-4107GK