Remove/install cover on gearshift lever - AR68.20-P-2310GI

MODEL 163.113 /154 /174 #A as of 289565,163.113 #X as of 754620,163.128 /157 /175 

Fig 1: Identifying Cover On Gearshift Lever

	Remove/install
1	Remove armrest lid (1)		AR68.20-P-2370GH
2	Remove plastic screws (5)
3	Remove stowage box (2)	Press the pin in the center of the rivet downwards for about 4 mm; then remove the rivet from above.
4	Remove selector lever paneling	Long wedge	Figure
5	Unscrew bolts (3)
6	Remove cover (4) from above	Carefully prize open at front (arrows) and at the sides.
		Long wedge	Figure
7	Detach connector from lower control panel control module	3 connector.
8	Install in the reverse order

Fig 2: Identifying Assembly Wedge (115 589 03 59 00)