  |
Removing, installing |
|
|
 |
The shock absorber with front spring does not have to be removed to remove and install the upper wishbone |
|
|
 Installation |
Replace self-locking bolts and nuts |
|
|
| 1 |
Remove front wheel |
|
|
 |
|
|
AP40.10-P-4050Z |
| 2 |
Press follower joint (8) out of steering knuckle (5) |
|
AR33.20-P-0500-01D |
| |
|
Thrust piece, M 10x1.5 |
Figure |
| |
|
Puller |
Figure |
| |
|
 |
*BA33.20-P-1002-01A |
| 3 |
Secure steering knuckle (5) with a wire (arrow) on the front spring to prevent it from tilting away |
Do not tension brake hose and electrical cables |
|
| 4.1 |
Remove windshield washer system reservoir partially and swing to one side |
Left side |
|
| 4.2 |
Remove BAS control module |
Left side |
AR42.31-P-6001A |
| 4.3 |
Remove BAS diaphragm travel sensor |
Left side |
AR42.31-P-6002A |
| 4.4 |
Detach upper left wishbone (6) from frame |
Guide bolt through under ABS hydraulic unit bracket. |
|
| |
|
Installation:
Tighten nut in ready-to-drive condition. |
*BA33.20-P-1007-01A |
| 5.1 |
Remove air cleaner |
Right side |
|
| 5.2 |
Detach upper right wishbone (6) from frame |
Remove plastic cover (6k) in wheelhouse and steady nut using a suitable box wrench. |
|
| |
|
Installation:
Tighten nut in ready-to-drive condition. |
*BA33.20-P-1007-01A |
| 6 |
Check follower joint of steering knuckle mount |
|
AR33.20-P-0425D |
| 7 |
Install in reverse order |
|
|