Retrofitting oddments box on driver's seat - AN91.10-P-0001A

MODEL 210 with CODE (450) Taxi version 

The oddments box can be mounted on the front seat cushion frame of the left front seat with a mounting bracket.

Fig 1: Locating Mounting Bracket

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Locating Mounting Bracket, Multi-Point Connector And Clip Nuts

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Oddments Box, Countersunk Sheet Metal Washers And Sheet Metal Screws

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removal
1	Bend back lug (arrow) on mounting bracket (2) in vise
2	Remove left front seat		AR91.10-P-1000F
3	Remove multi-point connector (1)	If necessary remove left front seat adjustment control module (N32/1).
	Installation
4	Knock mounting bracket (3) onto front seat cushion frame with rubber hammer	The two holes (arrows) must be positioned over the beads in the front seat cushion frame.
5	Punch holes for mounting bracket (3) in front seat cushion frame with awl, using mounting bracket (3) as template
6	Screw mounting bracket (3) onto front seat cushion frame
7	Install clip nuts (4) on mounting bracket (3)
8	Mount oddments box (5) on mounting bracket (3) with countersunk sheet metal washers (6) and sheet metal screws (7)
9	Install multi-point connector (1)
10	Install left front seat		AR91.10-P-1000F

The parts required for installation are listed in the following parts documents: