Dispose of strut - OS32.25-P-0122-01GC
| Risk of injury caused by drilling gas-filled assemblies or components (noncombustible gases) | Wear safety glasses and a face mask. | AS00.00-Z-0006-01A | |
| Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure. Risk of poisoning caused by swallowing hydraulic fluid. | Depressurize the hydraulic system completely before starting any work on the system. Wear protective clothing and safety glasses. | AS00.00-Z-0013-01A |
- Clamp spring strut in a vise.
Clamp in suspension strut so that hole then drilled is at highest point to allow gas to escape.
- Drill hole in suspension strut approx. 30 mm (A) from base of suspension strut with 5 mm dia. drill bit.
- Pump suspension strut empty by repeatedly pushing in and pulling out piston rod.
- Dispose of suspension strut.