Remove/install water repellent - AR88.85-P-2100PA

MODEL 203.2 

Fig 1: Identifying Water Repellent Remove/Install Components - Model 203.2 (1 Of 2)

Fig 2: Identifying Water Repellent Remove/Install Components - Model 203.2 (2 Of 2)

	Removing
1	Open engine hood
2	Pull out front water repellent(1)	From clip (2) on A-pillar.
3	Remove front water deflector (1)
4	Loosen center water deflector (4) below roof railing (7).	Pry center water repellent (4) out of clip (3) in center with assembly wedge.
		Mounting wedge	Figure
5	Remove center water repellent (4).	Do not damage roof railing (7). Slide water repellent (4) toward front, extend at rear toward side and afterwards remove toward rear.
6	Remove roof railing (7)	Only when removing rear water repellent (6).	AR77.40-P-5000PA
7	Mark position of rear water repellent (6).
8	Remove rear water repellent (6)	Mounting wedge	Figure
9	Mark position of clip (3).
10	Remove clip (3)
	Install
11	Install new clip (3) on roof gutter	Tension clip (3) with pliers.
12	Install rear water repellent (6).
13	Install roof railing (7)	Only when removing rear water repellent (6).	AR77.40-P-5000PA
14	Install center water repellent (4) on roof railing (7).	Slide water repellent toward front below roof railing (7) and move in to rear.
15	Install water repellent (1)

Fig 3: Identifying Wedge Tool (110 589 03 59 00)