Removing and installing driver's seat cushion - AR91.10-P-1070N

MODEL 215 

Fig 1: Identifying Driver'S Seat Cushion Remove/Install Components - Model 215 (1 Of 2)

Fig 2: Identifying Driver'S Seat Cushion Remove/Install Components - Model 215 (2 Of 2)

	Removal, installation
1	Move driver's seat all the way to the rear and seat cushion (1) forward
2	Remove covering from front seat frame		AR91.10-P-1200N
3	Unhook tensioning straps (2)	Installation  : Hook in tensioning straps (2) so that they are tensioned tightly
4	Disconnect seat heater connector (2) and seat ventilation connector (4) from left and right convenience seat adjustment control module (N31, N32)	With automatic child seat recognition sensor (ACRS) on the passenger seat, disconnect left and right convenience seat adjustment control module connector (N31, N32) in addition
5	Move seat backrest completely forward and pivot covering on tensioning element (5) upward (see arrows)
6	Unscrew screw (6)		*BA91.10-P-1005-01C
7	Disconnect horizontal seat cushion adjustment servo motor connector (X54/16) from seat cushion motor (M26m6)
8	Move driver's seat completely forward and move front seat cushion (1) upward
9	Pull seat cushion (1) out of front and rear sliders (7, 8) toward front and remove	Installation  : Slide seat cushion (1) correctly into the front and rear sliders (7, 8) Grease sliders (7, 8)
			*BR00.45-Z-1007-06A
10	Install in opposite order
11	Check seat cushion adjustment for proper function

FRONT SEATS

Number	Designation		Model 215
BA91.10-P-1005-01C	Screw for seat cushion adjustment on cross member	Nm	20

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1007-06A	Grease	A 001 989 37 51