Remove/install crank window in rear door - AR72.12-P-1910GH

MODEL 163.113 /128 /136 /154 /157 /172 /174 /175 

Fig 1: Identifying Crank Window Components In Rear Door

	Remove/install
	Injury hazard  due to hands being crushed when window glass is not secure	Secure window glass to prevent it from falling down.	AS67.00-Z-0002-01A
1	Remove door lining from rear door		AR72.12-P-1010GH
2	Remove inner sealing rail		AR72.10-P-1600GH
3	Remove outer sealing rail		AR72.10-P-1700GH
4	Pull foil off of inner door panel	Installation:  Replace door foil if damaged.
5	Remove loud speaker		AR82.62-P-7874GH
6	Unscrew bottom mount (2) on window lift rail (3)	Installation:  Apply glue to screw.	*BR00.45-Z-1011-02A
			*BA72.12-P-1006-01C
7	Set crank window (1) down in bottom of door
8	Loosen window guide rail (4)	Loosen window guide rail only up to fixed window. Installation:  coat window guide rail with solution of soap and water.
9	Remove crank window (1) out of window shaft upward
10	Install in the reverse order

Rear door

Number	Designation		Model Series 163
BA72.12-P-1006-01C	Bolt, bracket to window regulator	Nm	2,5

Repair materials

Number	Designation	Order number
BR00.45-Z-1011-02A	Quick glue	A 003 989 31 71