Adjusting crank window in front door - AR72.10-P-1950GH

MODEL 163 

Fig 1: Identifying Crank Window And Screw

	Checking
1	Check installation position of crank window on window frame	Left figure, crank window not completely closed, edge of glass parallel to window rail
2	Check installation position at vertical window rail	Left figure, horizontal arrows, crank window should make complete contact in window rail
	Removal, installation
3	Remove door liner on front door		AR72.10-P-1000GH
4	Remove foil from inner door panel	Installation:  Replace damaged foil
	Adjusting
5	Loosen screw (2)
6	Correct crank window by moving up or down	Simultaneously press crank window toward rear in vertical window guide rail
7	Tighten screw (2)
8	Install in opposite order