Remove/install rear door - AR72.20-P-3500GH
MODEL 163
| Remove/Install | |||
|---|---|---|---|
| Risk of injury to fingers being jammed or pinched when Remove/install or aligning hoods, doors, trunk lid and sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | AS00.00-Z-0011-01A | |
| 1 | Remove liner on rear door | AR72.20-P-3520GH | |
| 2 | Disconnect or unscrew connectors (1) on rear door | ||
| 3 | Disconnect lines for wiper system (2) from wiper motor and pull out of rear door | ||
| 4 | Remove gas-operated strut for rear door | AR72.20-P-3600A | |
| 5 | Unscrew bolts (3) on door hinge | ||
| *BA72.20-P-1003-02C | |||
| 6 | Remove rear door (4) with aid of helper | ||
| 7 | Install in the reverse order | AR60.00-P-0700-01GH *BE60.00-P-1003-01D |
Test and adjustment values, gap dimensions at hoods, doors and covers
| Number | Designation | Model 163 | |||
|---|---|---|---|---|---|
| BE60.00-P-1003-01D | Gap dimension | Rear door to roof | Dimension "E" | mm | 9.5 ± (0.5) |
| Rear door to D-pillar | Dimension "F" | mm | 5.0 ± (0.5) | ||
| Rear door to D-pillar | Dimension "G" | mm | 5.0 ± (0.5) | ||
| Rear door to rear fender | Dimension "M" | mm | 5.0 ± (0.5) | ||
| Fig., see | AR60.00-P-0700-01GH | ||||
| Number | Designation | Model 163 | |
|---|---|---|---|
| BA72.20-P-1003-02C | Bolt, door hinge to rear door | Nm | 55 |