Removing and installing power window motor in front door - AR72.29-P-1860GH

MODEL 163 

Fig 1: Identifying Power Window Motor Components In Front Door

	Removal, installation
1	Remove door liner on front door		AR72.10-P-1000GH
2	Pull door foil off of inner door panel	Installation:  Replace damaged foil
3	Unscrew screws (1)	Protect motor against falling
			Figure
			*BA72.29-P-1001-01A
4	Disconnect connector (2) from power window motor (M10/3 or M10/4)
5	Remove power window motor (M10/3 or M10/4) from door	Installation:  Grease gear on motor lightly When installing observe hole pattern for mounting
6	Install in opposite order

Electrical equipment inside doors

Number	Designation		Model 163
BA72.29-P-1001-01A	Bolt for power window motor in front door	Nm	5

Fig 2: Identifying Torx Bit Set (000 589 01 10 00)