Remove/install extinguishing agent line in left wheelhouse - AR86.10-P-0109MB

MODEL 220.1 /8 with CODE (Z04) Light armoring with CODE (Z07) Top protection with fire extinguishing system 

Fig 1: Identifying Extinguishing Agent Line In Left Wheelhouse Remove/Install Components - Shown On Model 220.178

	Remove/Install
1	Ignition Off, detach transmitter key from the electronic ignition switch control unit
2	Remove fuses no. 54 and no. 58 from rear fuse and relay module	The rear fuse and relay module is located below the right rear seat See ↓
		Fuse assignment of rear fuse and relay box	GF54.15-P-1256-01MB
3	Remove spare wheel	See Operator's Manual
4	Remove extinguishing agent reservoir threaded connection		AR86.10-P-0103MB
5	Disconnect threaded connection (3) from left extinguishing agent reservoir	Installation:  Observe tightening instructions. See ↓
		Tightening instructions for fire extinguishing system extinguishing agent lines.	AR86.10-P-0114-01A
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
6	Raise vehicle.	Do not damage extinguishing agent lines on fire extinguishing system when jacking up vehicle.
7	Detach left rear wheel
	Remove/install wheels, rotate if necessary		AP40.10-P-4050Z
8	Remove rear left fender liner
9	Remove rear bumper		AR88.20-P-2200M
10	Disconnect threaded connection (2) in wheelhouse	Installation:  Observe tightening instructions. See ↓
		Tightening instructions for fire extinguishing system extinguishing agent lines	AR86.10-P-0114-01A
11	Remove pipe clamps (4)	Mark position of pipe clamps (4) and extinguishing agent line in left wheelhouse (1). Installation:  First position bolts with pipe clamps (4) and then tighten pipe clamps (4) after aligning and screwing (2, 3) extinguishing agent line in left wheelhouse (1).
			*BA86.10-P-1001-01B
12	Remove extinguishing agent line in left wheelhouse (1)	Do not bend extinguishing agent line in left wheelhouse (1)
13	Install in the reverse order
14	Perform self-test for fire extinguishing system		AR86.10-P-0101-01MB

FIRE EXTINGUISHING SYSTEM