Remove/install extinguishing agent reservoir paneling - AR86.10-P-0103MB

MODEL 220.1 /8 with CODE (Z04) Light armoring with CODE (Z07) Top protection with fire extinguishing system 

Fig 1: Identifying Extinguishing Agent Reservoir Paneling And Expanding Clip

	Remove/Install
1	Open trunk lid	See Operator's Manual
2	Remove trunk floor	See Operator's Manual
3	Remove expanding clip (2)	Installation:  Check expanding clip (2), replace if necessary
4	Remove extinguishing agent reservoir paneling (1)	The extinguishing agent reservoir paneling (1) can vary depending on the equipment
5	Install in the reverse order