Check vehicle level at front and rear axle with electronic inclinometer, adjust if necessary - AR40.20-P-0301D

MODEL 210.08 /28 /6 

Shown on model 210.08/28 

Fig 1: Identifying Inclination Meter, Measurement Sensor And Measuring Plate - Shown On Model 210.08/28

Shown on model 210.08/28 

Fig 2: Checking Vehicle Level At Front And Rear Axle With Electronic Inclinometer - Shown On Model 210.08/28

Modification notes

22.2.00	Value changed from 8.2 to 7.2°	Value in BE40.20-P-1002-02D changed for model 210.6	*BE40.20-P-1002-02D
22.2.00	Value changed from 2.0 to 1.3°	Value in BE40.20-P-1002-03D changed for model 210.6	*BE40.20-P-1002-03D

	Checking
	On vehicles with level control  a vehicle level too low should not be corrected by changing the level control connection rod (control point).	Check function of level control. If OK, adjust the vehicle level by changing the spring or spring rubber mount.
1	Observe general information on chassis alignment.	Following repair work forcefully move vehicle up and down several times before measuring.	AR40.20-P-0201A
2	Install measuring plate (086b) in the recess in the lower wishbone.	The groove in the measuring plate (086b) should be at an angle of 90° to the direction of travel. Clean measuring point at bottom wishbone. Remove metal chips from measuring plate. Measuring plate is magnetic, information on data carriers, e.g. floppy discs, credit cards, etc. can be rendered unusable.	*WE58.40-Z-1002-15A
3	Check vehicle level at the front axle  via the wishbone inclination.	Attach measurement sensor (086a) (connecting cable pointing to center of vehicle) and store each measured value. Left front measuring point 1 Right front measuring point 2	*WE58.40-Z-1002-15A
			*BE40.20-P-1002-02D
4	Check vehicle level at the rear axle  via the rear axle shaft inclination.	Attach measurement sensor (086a) to left and right rear axle shaft (connecting cable pointing to center of vehicle) and store each measured value. Clean measuring points on rear axle shaft Left rear measuring point 3 Right rear measuring point 4	*WE58.40-Z-1002-15A
			*BE40.20-P-1002-03D
		Vehicle level outside of tolerance on front and rear axle ↓.
		Adjust vehicle level by changing the springs or spring rubber mounts.	AR40.20-P-0300-01B

Vehicle level - front axle

Number	Designation		Model 210.08/28	Model 210.6
BE40.20-P-1002-02D	Vehicle level - front axle	∠ °	+1.2 (-2.1/+1.4)	+7.2 (-2.2/+1.6)

Vehicle level - rear axle

Number	Designation		Model 210.08/28 with level control	Model 210.08 without level control	Model 210.6 with level control
BE40.20-P-1002-03D	Vehicle level - rear axle	∠ °	+1.9 (±1.0)	+2.3 (± 1.0)	+1.3 (± 1.0)

Workshop equipment

WE58.40-Z-1002-15A

Electronic clinometer