Removing and installing TELE AID emergency call system control module - AR82.95-P-0005D: Notes

MODEL 208.4 with CODE (347) TELE AID emergency call system (D2B) 

European version 

Illustrated on permanently installed telephone code 316 

Fig 1: Identifying TELE AID Emergency Call System Control Module Remove/Install Components

	Removal, installation
1	Connect quiescent current retention unit		*WH58.30-Z-1012-09A
2	Disconnect ground lead from battery		AR54.10-P-0003A
3	Remove rear assembly wall		AR68.74-P-1000KA
4	Pull connection lead and D2B connection lead off of TELE AID control module (A35/8)	Do not kink or stretch fiber optic cable Install caps on fiber optic cable connector and module connection	AR82.95-P-0005-01A
5	Unscrew TELE AID control module (A35/8) from mount with 4 screws (1) and pull out
6	Install in opposite order