Removing and installing upper wishbone - AR33.20-P-0500B

MODEL 170, 202, 208 

Fig 1: Identifying Upper Wishbone Remove/Install Components - Model 170, 202, 208

	Removal and installation
	To remove the upper wishbone the shock absorber must be installed
Installation	Replace self-locking bolts and nuts
1	Unscrew nut (6c)		*BA33.20-P-1002-01A
2	Screw thrust piece (043a) onto the ball pivot of the follower joint		Figure
3	Using puller (043), press follower joint out of upper wishbone (6)	Clean tapered connection	Figure
4	To prevent steering knuckle from tilting away, fasten it to the shock absorber with a piece of wire (arrow)	Do not subject brake hose and electric cables to tension.
5.1	Remove left upper wishbone from frame	Tighten nut in ready-to-drive condition.
			*BA33.20-P-1007-01A
5.2	Remove right upper wishbone from frame	Tighten nut in ready-to-drive condition.
		Model 202	AR33.20-P-0500-03A
		Model 170 : Remove air cleaner housing	*BA33.20-P-1007-01A
6	Check follower joint		AR33.20-P-0425A
7	Install in reverse order

WHEEL LOCATION, WHEEL HUB

Number	Designation			Model 170	Model 202	Model 208
BA33.20-P-1002-01A	Self-locking nut, follower joint of upper wishbone to steering knuckle	First time	Nm	45	45	45
		Check torque	Nm	-	-	-
BA33.20-P-1007-01A	Self-locking nut, upper wishbone to front end		Nm	65	65	65

Fig 2: Identifying Thrust Piece (210 589 04 63 00)

Fig 3: Identifying Puller (124 589 03 33 00)