Removing and installing lower wishbone - AR33.20-P-0510B

MODEL 170, 202, 208

Illustrations show model 202

Fig 1: Identifying Lower Wishbone Remove/Install Components (1 Of 2) - Model 170, 202, 208

Fig 2: Identifying Lower Wishbone Remove/Install Components (2 Of 2) - Model 170, 202, 208

	Removal, installation
1	Remove front wheel		AP40.10-P-4050Z
2	Remove front spring		AR32.20-P-0200B
3	Remove torsion bar fixing bracket (22b)		*BA32.20-P-1001-02C
4	Unscrew nut from supporting joint		*BA33.20-P-1004-01A
5	Screw thrust piece (044a) onto the ball pivot of the supporting joint		Figure
6	Using puller (044), press supporting joint out of steering knuckle	Clean tapered connection, if necessary	Figure
7	Remove shock absorber (11) from wishbone		*BA32.25-P-1003-01B
8	Remove lower wishbone from frame floor	Model 170: Remove lower engine compartment lining	AR33.10-P-0200-01B
		Installation: Tighten nuts in the ready-to-drive condition.	AR40.20-P-0322-01B
		Installation: Install repair bolts. If repair bolts are already installed, observe installed position and install bolts in the same position again. Observe technical modification ↓	*BA33.20-P-1009-01A
		Bearing bracket of lower wishbones	BT33.20-P-9308-01B
9	Unscrew supporting joint nut on wishbone		*BA33.20-P-1006-01A
10	Screw thrust piece onto the ball pivot of the supporting joint		Figure
11	Using puller, press supporting joint out of lower wishbone	Clean tapered connection, if necessary	Figure
12	Check wishbone for distortion and corrosion
13	Install in reverse order
14	Perform chassis alignment check	Tighten nuts in ready-to-drive condition.	AR40.20-P-0200A

FRONT AXLE TORSION BAR

Number	Designation		Model 202	Model 208
BA32.20-P-1001-02C	Self-locking nut for fastening bracket on wishbone	Nm	20	20

FRONT AXLE TORSION BAR

Number	Designation		Model 170
BA32.20-P-1001-02C	Self-locking nut for fastening bracket on wishbone	Nm	20

FRONT AXLE SHOCK ABSORBER

Number	Designation		Model 202	Model 208	Model 170
BA32.25-P-1003-01B	Self-locking nut of shock absorber on wishbone	Nm	55	55	55

WHEEL LOCATION SYSTEM, HUB

Number	Designation		Model 170	Model 202	Model 208
BA33.20-P-1004-01A	Self-locking nut of supporting joint on steering knuckle	Nm	105	105	105
BA33.20-P-1006-01A	Self-locking nut of supporting joint on wishbone	Nm	105	105	105
BA33.20-P-1009-01A	Self-locking nut of lower wishbones on frame	Nm	120	120	120

Fig 3: Identifying Thrust Piece (140 589 00 63 00)

Fig 4: Identifying Puller (202 589 02 33 00)