Removing and installing door retaining strap - AR72.10-P-2100E

MODEL 202, 210 

Shown on rear door model 202 

Fig 1: Identifying Door Retaining Strap Components - Shown On Rear Door Model 202

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removing, installing
1	Remove window crank	Model 202 Only in the case of manual window lifter.	AR72.10-P-1100GV
2	Remove door liner of front door	Model 202	AR72.10-P-1000E
		Model 210	AR72.10-P-1000F
3	Remove door liner on rear door	Model 202	AR72.12-P-1010E
		Model 210	AR72.12-P-1010F
4	Pull foil off of inner door panel in front area	Replace damaged foil.
5	Pull off seal (6)
6	Unscrew bolt (5)	Avoid damaging paint	*BA72.10-P-1003-01A
N	Remove screw (9, 3 in total)	Installation:  When installing, tighten the screws at the face end first.	*BA72.10-P-1007-01A
8	Remove seal (6) from door strap
9	Remove door retaining strap through installation opening in inner door panel
10	Install in the reverse order

Torque Specification

Number	Designation		Model 202	Model 210
BA72.10-P-1003-01A	Bolt to door bracket at A-pillar	Nm	25	35
BA72.10-P-1007-01A	Bolt to door bracket at door	Nm	10	10