Removing and installing door liner on rear door - AR72.12-P-1010F
MODEL 210
Modification notes
| 29.7.98 | Cover and screw added on vehicles with SRS (side airbag) | Work step 3 | AR72.12-P-1010F |
| Clip for fixing control cable for interior door control added for the first time | Work step 9 | ||
| Screw on lower door lining (rear entrance lamp) no longer used | was work step 7 |
| Removing, installing | |||
| 1 | Press off handle recess (3) using assembly wedge. | Figure | |
| 2 | Unscrew screw (4) in the area of the interior door control | ||
| 3 | Unclip cover (11) and unscrew screw (12) | With code 293 (rear side airbag) | |
| 4 | Unscrew screw (1) on lock escutcheon (2) and remove lock escutcheon (2) downwards | ||
| 5 | Press off cover (5) under armrest and unscrew screw (6) | ||
| 6 | Unclip entrance lamp and disconnect electrical cable | ||
| 7 | Press door lining (8) off inner door panel at bottom, front and rear using assembly wedge | Figure | |
| 8 | Lift door lining (8) out of retaining clips at the top of the sealing rail using assembly wedge and at the same time pull away from the inner door panel | Figure | |
| 9 | Unhook control cable (14) on interior door control | ||
| 10 | Pull electrical connections off door lining (8) | ||
| 11 | Put down door lining (8) | ||
| 12 | Check film and clips on inner door panel and replace if necessary. | *BR00.45-Z-1004-02A | |
| 13 | Check clips (9) on door lining and replace if necessary | ||
| 14 | Install in reverse order |
Repair materials
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1004-02A | Adhesives | A 001 989 30 71 |