Triggering alarm with anti-towing sensor, function - GF80.50-P-3023A

MODEL 202 as of 1.6.97 up to 31.5.98, 208, 210.081 /281 up to 31.5.98, 210 (except 210.081 /281) from 1.3.97 to 31.5.98 with CODE (882a) Interior motion sensor (infrared) 

MODEL 202, 208, 210 (except, 208.4) as of 1.6.98 with CODE (551a) Anti-theft alarm (ATA) 

Function prerequisites 

The interior motion sensor (IMS) can be switched off only if

• the anti-theft alarm (ATS)  is activated and
• the TS  function has not been switched off. 

Function 

The anti-towing sensor (TS) monitors changes in the position of the parked vehicle which could be caused by an attempt to tow the vehicle away.

An alarm is triggered when the ATA receives a signal to trigger the alarm at the corresponding alarm input from the PSE control module (combined) (A37)  . The ATA control module (N26) then triggers the acoustic  and optical alarm  .

The alarm can be tripped a maximum of three times in sequence by the TS function.

	ATA interior motion sensor/anti-towing sensor/status indicator switch, location/purpose/design/function	with code 882 (interior motion sensor)	GF80.50-P-4103A
	ATA anti-towing sensor/status indicator switch	without code 882	GF80.50-P-4108C
	Activating anti-theft alarm (ATA), function	up to 5/98	GF80.50-P-2002C
		as of 6/98	GF80.50-P-2002I
	Acoustic alarm, function	up to 5/98	GF80.50-P-4005A
		as of 6/98	GF80.50-P-4005C
	Optical alarm, function	up to 5/98	GF80.50-P-4006A
		as of 6/98	GF80.50-P-4006C