Direction indicator/hazard flasher signal devices diagnosis, troubleshooting - AD82.25-P-5000A
MODEL 202 as of 1.6.97, 208, 210.081 /281, 210 as of 1.3.97
| Direction indicator/hazard flasher signal devices diagnosis, advanced information | AD82.25-P-2000A | ||
| Connecting Hand-Held Tester, reading out fault memory | AD00.00-P-2003A | ||
| Troubleshooting | |||
| Complaint | Possible cause | Note | Remedy/Test step |
| Direction indicator and hazard flasher faulty | Driver-side signal-acquisition and actuation module (SAM) (N10/1) | AD82.25-P-6000-01A | |
| Only direction indicator faulty | Cables | AD82.25-P-6000-05A | |
| Turn signal switch S4s1 | AD82.25-P-6000-04A | ||
| The following causes are only likely if other functions of the combination switch (e.g. wiping) are also faulty: CAN data buses between electronic ignition key and SAM (only if fanfare horns are also faulty). Electronic ignition switch control module (electronic ignition key, N73) Driver-side signal-acquisition and actuation module (SAM) (N10/1) |
AD82.25-P-6000-02A AD82.25-P-6000-01A |
||
| Only hazard flasher faulty | Cables Hazard flasher switch (S6/1s1) |
AD82.25-P-6000-06A AD82.25-P-6000-07A |
|
| Driver-side signal-acquisition and actuation module (SAM) (N10/1) | AD82.25-P-6000-01A | ||
| HHT cannot communicate with electronic ignition key (N73) and SAM (N10/1) | Cables Electronic ignition switch control module (electronic ignition key, N73) |
AD82.25-P-6000-03A AD82.25-P-6000-02A |
|
| HHT cannot communicate with SAM (N10/1) | The following causes are only likely if other functions of the combination switch (e.g. direction indicators, wipers) are also faulty: CAN data buses between electronic ignition key (N73) and (SAM) (N10/1) Electronic ignition switch control module (electronic ignition key, N73) Driver-side signal-acquisition and actuation module (SAM) (N10/1) |
AD82.25-P-6000-04A AD82.25-P-6000-02A AD82.25-P-6000-01A |
|
| Direction indicator faulty in one direction only | Cables | AD82.25-P-6000-05A | |
| Turn signal switch S4s1 | AD82.25-P-6000-02A | ||
| Electronic ignition switch control module (electronic ignition key, N73) Driver-side signal-acquisition and actuation module (SAM) (N10/1) |
AD82.25-P-6000-01A | ||
| Turn signal indicator does not click or flasher indicator lamp inoperative | Cables Ae1, Ae2 Instrument cluster (A1) | AD82.25-P-6000-08A | |
| Failure of individual flasher lamps | Cables | Left rear turn signal lamp | AD82.25-P-6000-09A |
| Corresponding lamp | Left front turn signal lamp | AD82.25-P-6000-09B | |
| Left auxiliary turn signal | AD82.25-P-6000-09C | ||
| lamp | AD82.25-P-6000-09D | ||
| Right rear turn signal lamp | AD82.25-P-6000-09E | ||
| Right front turn signal lamp Right auxiliary turn signal lamp |
AD82.25-P-6000-09F | ||
| Driver-side signal-acquisition and actuation | Outputs on left | AD82.25-P-6000-15A | |
| module (SAM) (N10/1) | Outputs on right | AD82.25-P-6000-15B |