Direction indicator/hazard flasher signal devices diagnosis, function check - AD82.25-P-3000A
MODEL 202 as of 1.6.97, 208, 210.081 /281, 210 as of 1.3.97
| Signal lamps Direction indicator/hazard warning flasher, diagnosis Basic knowledge |
AD82.25-P-2000A | ||
| Function check | |||
| Test step/Scope of test | Operation/Requirement | Specified value | Possible cause/Remedy |
| Function check of direction indicator | Move starter switch into position "2", position combination switch in position "indicate right" The corresponding turn signal indicator lamps must flash. | The corresponding turn signal indicator lamp flashes in the instrument cluster and the turn signal indicator clicks. | |
| Repeat procedure with combination switch in position "indicate left" | The corresponding turn signal indicator lamps must flash. The corresponding turn signal indicator lamp flashes in the instrument cluster and the turn signal indicator clicks. | ||
| Function check of hazard flasher | Move hazard flasher switch into "ON" position | All turn signal indicator lamps, the indicator lamp in the hazard flasher switch and the indicator lamps in the instrument cluster must flash. The turn signal indicator clicks. | |
| Function check of direction indicator lamp failure recognition | Unscrew turn signal lamps (E3e1, E4e1), move starter switch into position "2", position combination switch on "indicate right" | The corresponding turn signal indicator lamps must flash rapidly (3 Hz instead of 1.5 Hz). | |
| Repeat procedure with combination switch in position "indicate left" |