Removing and installing lining on C-pillar - AR68.30-P-4490FC

MODEL 210.0## ## as of 111291 

Fig 1: Identifying Lining On C-Pillar Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removing
1	Remove rear seat cushion		AR91.12-P-1700F
2	Remove belt end fitting (6) screw (5)
3	Unclip fastening (2)	The fastening is located approximately 16 cm below the upper edge of the trim.
			Figure
4	Remove paneling (1) in direction of arrow	Pull the trim parallel to the trim outline at an angle upwards/outwards away from the fastening. Intervene in the belt guide when pulling out.
5	Feed the belt strap through the opening in the paneling (1)
6	Remove all clips remaining in the vehicle	To do this turn clips (3) through 90°.
	Installing
7	Insert clips (3) into the paneling (1)
8	Feed the belt strap through the opening in the paneling (1)	The belt strap should not be twisted.
9	Insert paneling (1) into snap-in tabs (4)
10	Fasten paneling	Press down hard the fastening (2) and clip (3) areas.
11	Fasten belt end fitting (6)		*BA91.40-P-1001-01A
12	Install rear seat cushion		AR91.12-P-1700F

Seatbelts/emergency tensioning retractors

Number	Designation		Models 202, 208	Model 210
BA91.40-P-1001-01A	Screw on seat-belt end fitting.	Nm	35	35

Special tool 

Fig 2: Longitudinal Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.