Removing and installing power steering pump - AR46.30-P-0500CB
MODEL 202.133 /134 /193 /194 except CODE (480) Level control system at rear
Fig 1: Identifying Power Steering Pump Remove/Install Components Model 202.133 /134 /193 /194 Except Code (480)
| Removing, installing | |||
| 1 | Detach air intake hose | ||
| 2 | Slacken bolts (41a) on pulley | Figure | |
| *BA46.30-P-1007-01A | |||
| 3 | Remove poly V-belt | AR13.22-P-1202HB | |
| 4 | Remove pulley (41) | ||
| 5 | Draw off oil from reservoir | Figure | |
| 6 | Detach return line (30f) | Seal pipe connection with blind plug | |
| 7 | Unscrew high-pressure expansion hose (30i) | Seal pipe connection with blind plug | |
| *BA46.30-P-1003-01A | |||
| 8 | Detach bracket (30k) from power steering pump (30) | ||
| 9 | Detach power steering pump (30) | *BA46.30-P-1011-01A | |
| 10 | Install in the reverse order | ||
| 11 | Fill and bleed power steering pump | AR46.30-P-0010A |
| Number | Designation | Model 202.133/134/193/194 without level control | ||
|---|---|---|---|---|
| BA46.30-P-1003-01A | High-pressure expansion hose to power steering pump | M14x1.5 | Nm | - |
| M16x1.5 | Nm | 45 | ||
| BA46.30-P-1007-01A | Bolt, pulley to power steering pump | Nm | 25 | |
| BA46.30-P-1011-01A | Nut, power steering pump to timing case | Nm | 20 | |