Removing, installing viscous fan coupling - AR20.40-P-5660HB
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2000 Mercedes-Benz C43, 2000 Mercedes-Benz C280, 2000 Mercedes-Benz C230, 1999 Mercedes-Benz C43, and 1999 Mercedes-Benz C280. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 605, 606 in MODEL 124
ENGINE 606.961 in MODEL 140
ENGINE 605 in MODEL 202
ENGINE 602.982, 605, 606.912 /962 in MODEL 210
| Removal, installation | |||
| 1.1 | Remove charge air pipe (110) | Engine 605.960 in model 202 | AR09.41-P-1311H |
| Engine 602.982, 605.962 in model 210 | |||
| 2.1 | Remove fan shroud (7), place over the fan (1) | Engine 602.982, 605 Engine 606.912 in model 210 |
|
| Adjust fan shroud | AR20.40-P-6800-01HA | ||
| 2.2 | Turn fan shroud ring (7a) to release it from the engaging studs on the fan shroud, remove | Engine 606 in model 124 Engine 606.961 in model 140 |
|
| 3.1 | Remove fan shroud (7) and lift up and out | Engine 606.962 in model 210 |
|
| 4 | Insert counter-holder (9) at the belt pulley of the coolant pump | Figure | |
| 5 | Unbolt viscous fan clutch (2) together with fan (1), remove | On engine 605 in models 124, 202, remove viscous fan coupling together with fan shroud (7) |
Figure |
| *BA20.40-P-1002-01A | |||
| *BA20.40-P-1003-01A | |||
| 6 | Unbolt fan (1) at viscous fan clutch (2) | ||
| *BA20.40-P-1002-01A | |||
| 7 | Install in the reverse order |
| Number | Designation | Engine 605, 606 | Engine 601, 602 except 602.982, 603 | |
|---|---|---|---|---|
| BA20.40-P-1001-01A | Bolt of fan to viscous coupling | Nm | 10 | 10 |
| BA20.40-P-1002-01A | Tightening bolt of viscous fan coupling to bearing body with approved special tool | Nm | 40 | 40 |
| BA20.40-P-1003-01A | Tightening bolt of viscous fan coupling to bearing body with torque wrench | Nm | 45 | 45 |