Remove and install power window on rear door - AR72.12-P-1810E

MODEL 202 

Fig 1: Identifying Power Window On Rear Door Remove/Install Components - Model 202

MODIFICATION NOTES

21.4.95

Grease sliding jaws

Step no. 5

	Remove/install
1	Remove/install window crank	Window open	AR72.10-P-1100GV
2	Remove/install rear door liner		AR72.12-P-1010E
3	Remove foil on inner door panel, glue on	Installation:  Before installing foil check power window for easy motion
4	Unclip retainer (4) from window lift rail (5)
5	Extend crank window (6) toward rear out of slider (2) with window lift rail (5) and push upwards in window guide rail	Secure against falling down with assembly wedge	Figure
		When installing grease window lift rail and slider with multi-purpose grease	*BR00.45-Z-1009-06A
6	Drill out pop rivets (4 each) or cut out	For drilling out: 4.8 mm ø dia. bit
		For cutting out: Spherical cutter	*WH58.30-Z-1002-01A
7	Unhook window lift from inner door panel with installation hook and remove through installation opening	Disconnect connector from power windows
8	Install in the reverse order

Special tools 

Fig 2: Identifying Assembly Wedge (110 589 03 59 00)

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1002-01A	Ball cutter, dia. 12 mm

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1009-06A	Multi-purpose paste	A 000 989 80 51 10