Disassembling and assembling door liner on rear door - AR72.12-P-1040E

MODEL 202 

Fig 1: Identifying Door Liner On Rear Door Disassembling/Assembling Components - Model 202

	Disassembly
1	Remove door liner on rear door		AR72.12-P-1010E
2	Place door liner on suitable surface	Avoid damaging
3	Remove retainers (3) and trim strip (2)
4	Cut off plastic nubs (5) and remove armrest	Use chisel to cut off
5	Cut off plastic nubs (7) and remove door pocket	Use chisel to cut off
	Assembly
6	Position door pocket (6) and screw down	On new door pocket and armrest shorten plastic pins (8) to height of rear door liner Screws (10 each) N 914 138 004 000 Washers (10 each) N 000 125 005 312
7	Position armrest (4) and screw down	Screws (10 each) N 914 138 004 000 Washers (10 each) N 000 125 005 312
8	Position trim strip (2) and fasten with retainers (3)	Replace damaged retainers
9	Install door liner on rear door		AR72.12-P-1010E