Removing, installing ADS control unit - AR32.32-P-0500A

MODEL 129 as of 1.9.95 

Fig 1: Identifying ADS Control Unit Components

			Removing, installing
1	Remove screws (a)
2	Take off mounting frame (b)
3	Unclip connector (c) at mounting frame (b) (arrows) and take out to the side
4	Install in the reverse order	If the ADS control module (N51) is replaced: always  check vehicle level at front and rear axles, set and restore normal level  in control module.	AR40.20-P-0300E
		An ADS control module with red colored marking  has to be reprogrammed when replaced and again identified with a red colored dot  .	AD32.32-P-2000-01A