Gasoline injection and ignition system (ME-SFI) diagnosis - diagnostic trouble code memory (Fault Codes P0100, P0105, P0110, P0115, P0120, P0130, P0133, P0135, P0136, P0140, P0141, P0150, P0153, P0155, P0156, P0160, P0161, P0170, P0173, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304) - AD07.61-P-4000B
ENGINES 113.940 /942 /943 up to 31.5.00,
113.961
Fault codes from P0000 to P0304
| Hazard from contact with parts conducting high voltages. | Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out work on the ignition system. | AS15.10-Z-0001-01A | |
| Lethal hazard from being drawn into rotating vehicle parts | Do not reach into rotating parts. Wear closed and close-fitting work clothes. Secure area of rotating vehicle components against unauthorized access. |
AS00.00-Z-0004-01A | |
| Risk of explosion from fuel igniting, risk of poisoning from inhaling and swallowing fuel as well as risk of injury to eyes and skin from contact with fuel. | No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| Notes on avoiding damage to the ignition system | Engines 104, 111, 112, 113, 119, 120 with ME-SFI fuel injection and ignition system | AH15.10-P-0002-01D | |
| The fault code cannot be read out with the pulse counter | |||
| ■ Symbol for USA vehicles for activation of the malfunction indicator lamp CHECK ENGINE • Symbol for EURO3 vehicles for activation of the engine diagnosis malfunction indicator lamp (is indicated in the HHT as ■) The malfunction indicator lamp does not go on until a fault relevant for the exhaust system was stored during the last driving cycle (exception misfire "damaging to TWC", malfunction indicator lamp goes on immediately). |
|||
| Ignition: On | |||
| Connect hand-held-tester (HHT), read out diagnostic trouble code memory | AD00.00-P-2000-03A | ||
| Gasoline injection and ignition system (ME-SFI) diagnosis - prerequisites | AD07.61-P-2000B | ||
| Check and adjust engine | Engine diagnosis manual | ||
| Diagnostic trouble code memory | |||
| Fault code |
possible cause | Note | Remedy |
| No fault code | No fault detected | Depending on the complaint, carry out testing of ME-SFI electrical system in full | AD07.61-P-6000B AD07.61-P-6001B |
| AD07.61-P-6002B | |||
| AD07.61-P-6003B | |||
| P0100 ■ • | Hot-film mass air flow sensor (B2/5) | AD07.61-P-6000-04B | |
| Fault code description for hot film mass air flow sensor, ME-SFI | AD07.61-P-4000-01B | ||
| P0105 ■ • | Pressure sensor (B28) | AD07.61-P-6000-06A | |
| Fault code description for pressure sensor, ME-SFI | AD07.61-P-4000-02A | ||
| P0110 ■ • | Intake air temperature sensor (in the hot film mass air flow sensor B2/5) | AD07.61-P-6000-05A | |
| Intake air temperature sensor Fault code description, ME-SFI |
AD07.61-P-4000-03A | ||
| P0115 ■ • | Coolant temperature sensor (B11/4) | AD07.61-P-6000-08A | |
| Fault code description for coolant temperature sensor, ME-SFI | AD07.61-P-4000-04A | ||
| P0120 | Actual value potentiometer in the throttle valve actuator (M16/6) | AD07.61-P-6002-03A | |
| Fault code description for actual value potentiometer in the throttle valve actuator, ME-SFI | AD07.61-P-4000-48A | ||
| P0130 ■ • | A Oxygen sensor on right upstream of TWC (G3/4) B Oxygen sensor on right upstream of TWC (G3/4) voltage increase too small |
AD07.61-P-6000-11A | |
| Fault code description for oxygen sensor signal, ME-SFI | AD07.61-P-4000-06A | ||
| P0133 ■ • | A Oxygen sensor on right upstream of TWC (G3/4) aging correction variable exceeded B Oxygen sensor on right upstream of TWC (G3/4) aging of cycle duration too long C Oxygen sensor on right upstream of TWC (G3/4) aging of oxygen sensor too slow |
AD07.61-P-6000-11A | |
| Fault code description for aging of oxygen sensor upstream of TWC, ME-SFI | AD07.61-P-4000-07A | ||
| P0135 ■ • | Oxygen sensor heating of oxygen sensor on right upstream of TWC (G3/4) | AD07.61-P-6000-13A | |
| Fault code description for oxygen sensor heating, ME-SFI | AD07.61-P-4000-08A | ||
| P0136 ■ • | Oxygen sensor on right downstream of TWC (G3/6) | AD07.61-P-6000-15A | |
| Fault code description for oxygen sensor signal, ME-SFI | AD07.61-P-4000-06A | ||
| P0140 ■ • | Oxygen sensor on right upstream of TWC (G3/4) | AD07.61-P-6000-11A | |
| Fault code description for oxygen sensor signal, ME-SFI | AD07.61-P-4000-06A | ||
| P0141 ■ • | Oxygen sensor heating of oxygen sensor on right downstream of TWC (G3/6) | AD07.61-P-6000-17A | |
| Fault code description for oxygen sensor heating, ME-SFI | AD07.61-P-4000-08A | ||
| P0150 ■ • | A Oxygen sensor on left upstream of TWC (G3/3) B Oxygen sensor on left upstream of TWC (G3/3) voltage increase too small |
AD07.61-P-6000-10A | |
| Fault code description for oxygen sensor signal, ME-SFI | AD07.61-P-4000-06A | ||
| P0153 ■ • | A Oxygen sensor on left upstream of TWC (G3/3) aging of correction variable exceeded B Oxygen sensor on left upstream of TWC (G3/3) aging of cycle duration too long C Oxygen sensor on left upstream of TWC (G3/3) aging of oxygen sensor too slow |
AD07.61-P-6000-10A | |
| Fault code description for aging of oxygen sensor upstream of TWC, ME-SFI | AD07.61-P-4000-07A | ||
| P0155 ■ • | Oxygen sensor heating of oxygen sensor on left upstream of TWC (G3/3) | AD07.61-P-6000-12A | |
| Fault code description for oxygen sensor heating, ME-SFI | AD07.61-P-4000-08A | ||
| P0156 ■ • | Oxygen sensor on left downstream of TWC (G3/5) | AD07.61-P-6000-14A | |
| Fault code description for oxygen sensor signal, ME-SFI | AD07.61-P-4000-06A | ||
| P0160 ■ • | Oxygen sensor on left downstream of TWC (G3/5) | AD07.61-P-6000-14A | |
| Fault code description for Oxygen sensor signal, ME-SFI | AD07.61-P-4000-06A | ||
| P0161 ■ • | Oxygen sensor heating of Oxygen sensor on left downstream of TWC (G3/5) | AD07.61-P-6000-16A | |
| Fault code description for oxygen sensor heating, ME-SFI | AD07.61-P-4000-08A | ||
| P0170 ■ • | A Self-adaptation of the "partial load" mixture formation for right cylinder bank to limit value of ME-SFI control module (N3/10) B Self-adaptation of the "idle" mixture formation for right cylinder bank to limit value of ME-SFI control module (N3/10) |
Air leak, fuel injectors of diaphragm-type pressure regulating valve, wear to engine | |
| Fault code description for self-adaptation of mixture formation to limit, ME-SFI | AD07.61-P-4000-09A |
| P0173 ■ • | A Self-adaptation of the "partial load" mixture formation for left cylinder bank to limit value of ME-SFI control module (N3/10) B Self-adaptation of the "idle" mixture formation for left cylinder bank to limit value of ME-SFI control module (N3/10) |
Air leak, fuel injectors of diaphragm-type pressure regulating valve, wear to engine | |
| Fault code description for self-adaptation of mixture formation to limit, ME-SFI | AD07.61-P-4000-09A | ||
| P0201 ■ • | Fuel injector (Y62y1) cylinder 1 | AD07.61-P-6000-18A | |
| Fault code description for fuel injectors, ME-SFI | AD07.61-P-4000-10B | ||
| P0202 ■ • | Fuel injector (Y62y2) cylinder 2 | AD07.61-P-6000-19B | |
| Fault code description for fuel injectors, ME-SFI | AD07.61-P-4000-10B | ||
| P0203 ■ • | Fuel injector (Y62y3) cylinder 3 | AD07.61-P-6000-20B | |
| Fault code description for fuel injectors, ME-SFI | AD07.61-P-4000-10B | ||
| P0204 ■ • | Fuel injector (Y62y4) cylinder 4 | AD07.61-P-6000-21B | |
| Fault code description for fuel injectors, ME-SFI | AD07.61-P-4000-10B | ||
| P0205 ■ • | Fuel injector (Y62y5) cylinder 5 | AD07.61-P-6000-22B | |
| Fault code description for fuel injectors, ME-SFI | AD07.61-P-4000-10B | ||
| P0206 ■ • | Fuel injector (Y62y6) cylinder 6 | AD07.61-P-6000-23B | |
| Fault code description for fuel injectors, ME-SFI | AD07.61-P-4000-10B | ||
| P0207 ■ • | Fuel injector (Y62y7) cylinder 7 | AD07.61-P-6000-38A | |
| Fault code description for fuel injectors, ME-SFI | AD07.61-P-4000-10B | ||
| P0208 ■ • | Fuel injector (Y62y8) cylinder 8 | AD07.61-P-6000-39A | |
| Fault code description for fuel injectors, ME-SFI | AD07.61-P-4000-10B | ||
| P0300 ■ • | A Misfire B Misfire "damaging to TWC" |
AD07.61-P-6001-11A AD07.61-P-6001-12B AD07.61-P-6001-13B AD07.61-P-6001-14B AD07.61-P-6001-15B AD07.61-P-6001-16B AD07.61-P-6001-20A AD07.61-P-6001-21A AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0301 ■ • | A Misfire in cylinder 1 B Misfire in cylinder 1 "damaging to TWC" |
AD07.61-P-6001-11A AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0302 ■ • | A Misfire in cylinder 2 B Misfire in cylinder 2 "damaging to TWC" |
AD07.61-P-6001-12B AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0303 ■ • | A Misfire in cylinder 3 B Misfire in cylinder 3 "damaging to TWC" |
AD07.61-P-6001-13B AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0304 ■ • | A Misfire in cylinder 4 B Misfire in cylinder 4 "damaging to TWC" |
AD07.61-P-6001-14B AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B |