Measure end clearance of piston rings - AR03.10-P-7311-01V
Modification notes
| 12.6.02 | Value in series 1001 for engine 113.967 modified from 0.012...0.060 to 0.033...0.07 and from 0.010...0.030 to 0.01...0.04 | Value in BE03.10-P-1001-05B for engine 113.967 modified | *BE03.10-P-1001-05B |
Inspection data for piston rings
| Number | Designation | Engine 112.910/ 911/912 | Engines 112.920/ 921/922/923/ 940/941/942/ 943/944/945/ 946/947/948/ 960, Engine 113.940/941/ 942/943 | Engines 113.944/980/ 981/982/984 | ||
|---|---|---|---|---|---|---|
| BE03.10-P-1001-05B | Piston ring vertical clearance | Groove 1 | mm | 0.012...0.060 | 0.012...0.060 | 0.012...0.060 |
| Groove 2; | mm | 0.010...0.030 | 0.010...0.030 | 0.010...0.030 | ||
Inspection data for piston rings
| Number | Designation | Engines 113.960/961/ 962/963/964/ 965/968/971 | Engine 113.967 | ||
|---|---|---|---|---|---|
| BE03.10-P-1001-05B | Piston ring vertical clearance | Groove 1 | mm | 0.012...0.060 | 0.033...0.070 |
| Groove 2 | mm | 0.010...0.030 | 0.01...0.04 | ||
Commercially available tools
| Number | Designation |
|---|---|
| WH58.30-Z-1004-12A | Feeler gauge |
- Measure the side clearance of the compression rings between the compression ring and the mounting groove in the piston with a
feeler gauge. Replace the compression rings or the piston if necessary.
The end clearance of the oil scraper ring cannot be checked because of its three-part design. The oil scraper ring must also be replaced when the compression rings are replaced.