LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1995 >> E420 >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Electrical System, Equipment & Instructions - 140 Chassis) >> Repair & Adjustments >> Battery disconnection switch - ra54001400008x(0008)

Battery disconnection switch - ra54001400008x(0008)

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Model 140 as of 06/93 

Vehicles shipped overseas from a German North Sea port are equipped with a battery disconnection switch in the trunk on the negative terminal of the battery as of approx. 06/93. This battery disconnection switch interrupts the connection to ground preventing quiescent current loads from discharging the battery during transport or longer periods of inoperation.

IMPORTANT Do not switch battery disconnection switch to "Off"  position with engine running.

Interruption of the circuit with the engine running can lead to extensive damage to the vehicle electrical system.

Such damage is not covered by the warranty and will be not be honored as a guarantee claim under any circumstances.

Fig 1: Identifying Battery Disconnection Switch
G05439013Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Before interrupting the circuit with the battery disconnection switch, lock vehicle manually or with infrared remote control with trunk lid open. Retract the trunk lid grip by actuating the switch on the trunk lock.

Fig 2: Identifying Trunk Lock
G05439010Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

IMPORTANT The pin in the trunk lid auxiliary lock should not be extended, if necessary repeat locking procedure.

Fig 3: Identifying Trunk Lid Auxiliary Lock
G05439012Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
NOTE: On vehicles without switch (as of approx. 01/95) retract grip manually with lever 1 and switch off closing assist with switch 2.
Fig 4: Identifying Lever And Switch
G05439011Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

The battery disconnection switch must be removed before delivering the vehicle to the customer.

After removing perform following work:

Code radio (82-7502).

Code auto pilot system (APS)

if present (82-7502)

Synchronize power windows (FUNCTION OF CONVENIENCE CONTROL (POWER WINDOWS AND TILTING/SLIDING ROOF) ).

Set timer for stationary heater, where applicable.

On vehicles with ADS reactivate steering angle sensor (32-0600) .

Return of the removed battery disconnection switches is only planned for countries participating in the ZVL Germersheim replacement part return program. Information on return shipment is available through parts channels. In all other countries scrap the battery disconnection switches.