Removal and installation of centrifugal governor - AR27.10-P-0280A: Notes
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
TRANSMISSION 722.5
| Removal, installation | |||
| 1 | Support transmission | ||
| 2 | Remove engine cross member (19) | ||
| 3 | Remove exhaust bracket (10) and U-bracket (11) by unscrewing self-locking nuts (7) | ||
| 4 | Remove shield (5) | ||
| 5 | Detach front propeller shaft (71) on transmission | Model 124 | ra4100107b050x |
| Model 129 | AR41.10-P-0050A | ||
| Model 140 | AR41.10-P-0050DA | ||
| Model 210 | AR41.10-P-0050B | ||
| 6 | Unhook exhaust system (60) at the rear mount | ||
| 7 | Unscrew speedometer shaft (9) or inductive sensor (85a) | ||
| 8 | Press in cover (46) and remove snap ring (43) and O-ring (48) | ||
| 9 | Remove centrifugal governor (50) | AR27.10-P-0280-01A | |
| AR27.10-P-0280-03A | |||
| 10 | Check regulating valve for ease of movement | AR27.10-P-0280-02A | |
| 11 | Install in reverse sequence |