Removing and installing headliner - AR68.30-P-4300E

MODEL 202 

Fig 1: Identifying Headliner Remove/Install Components - Model 202 (1 Of 2)

Fig 2: Identifying Headliner Remove/Install Components - Model 202 (2 Of 2)

	Removal, installation
1.1	Open tilting/sliding roof panel	Electrically operated tilting/sliding roof (code 412b or 414a)
2	Remove interior mirror
3	Remove front dome lamp		AR82.20-P-0110E
4	Remove sun visors
5	Remove grab handles
6	Remove rear dome lamp
7	Remove edge guard on door cutout
8	Remove lining on A-pillar		AR68.30-P-4050E
9	Remove lining on B-pillar	Do not remove seat belt end fitting	AR68.30-P-4700E
10	Remove lining on C-pillar	Do not remove seat belt end fitting	AR68.30-P-4490E
11	Remove front door	Right front door	AR72.10-P-0500E
12	Lower backrests on front seats
13	Move gearshift lever toward rear
14.1	Remove bar (3) at front of sliding roof cutout	Electrically operated tilting/sliding roof (code 412b or 414a) When installing hook clip (9) in with putty knife so that headliner is not damaged.
15	Pull clip (4) out of dome lamp cutout
16.1	Detach hook (6) toward rear	Vehicles without electrically operated tilting/ sliding roof
17.1	Detach headliner (2) at front of tilting/sliding roof frame	Electrically operated tilting/sliding roof (code 412b or 414a)
18.1	Detach clips (7)	Electrically operated tilting/sliding roof (code 412b or 414a) Detach from tilting/sliding roof frame with screwdriver through slot in rail (8). If clip (7) cannot be detached ↓ remove rail (8).
19	Pull headliner off of retaining strips (5)
20.1	Detach bar (arrows) on tilting/sliding roof frame toward front	Electrically operated tilting/sliding roof (code 412b or 414a)
21	Remove headliner through right front door
22	Reinstall in opposite order