LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1994 >> C220 >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Rear Axle - 140 Chassis) >> Testing & Repair >> Disassembling and assembling rear axle, adjusting gear set - AR35.31-P-0550 >> Disassemble/assemble rear axle center assembly, adjusting gear set - AR35.31-P-0550D >> Pressing ABS gear onto drive pinion Press-on sleeve for ABS gear - AR35.31-P-0550-31B

Pressing ABS gear onto drive pinion Press-on sleeve for ABS gear - AR35.31-P-0550-31B

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
REFER TO SHOP-MADE TOOLS Number of teeth on ABS gear: ↓ WF58.50-P-3531-04B
REFER TO BASIC KNOWLEDGE Characteristics, installation survey for rear axle center assemblies with 168 mm dia. crown wheel GF35.31-P-1000-01B 
REFER TO BASIC KNOWLEDGE Characteristics, installation survey for rear axle center assemblies with 185 mm dia. crown wheel GF35.31-P-1000-01C 
REFER TO BASIC KNOWLEDGE Characteristics, installation survey for rear axle center assemblies with 210 mm dia. ring gear GF35.31-P-1000-01D 

Press ABS gear (49) with shop-made spacer sleeve (013) onto drive pinion (47).

IMPORTANT

The number of teeth on the ABS gear (49) must correspond with the rear axle ratio.

Fig 1: Pressing ABS Gear With Shop-Made Spacer Sleeve Onto Drive Pinion
G04635083Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals