Replacing center and rear muffler - AR49.10-P-4940DA
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 104 in MODELS 124, 140, 202
ENGINE 111 in MODELS 124, 202
Shown on model 124 sedan
| Removal, installation | |||
| Risk of explosion from ignition. Risk of poisoning from inhaling and swallowing fuel. Risk of injury as a result of fuel coming into contact with skin and eyes. | No fire, naked flame or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| 1 | Remove exhaust system from flange connection | Model 202.028 E 36 AMG: pay attention to installation position and suspension of rear muffler, see ↓ |
|
| Notes on installation position and suspension of rear muffler | AH49.10-P-1000-02A | ||
| 2 | Place new rear muffler (9a) with plug connection exactly over the removed exhaust system and mark length of pipe of new rear muffler on the removed exhaust system | ||
| 3 | Cut through the pipe 80 mm from the marking (tolerance minus 10 mm) in direction of rear muffler so as to ensure an insertion depth of 70 - 80 mm | If center muffler faulty, the center and rear muffler unit must be replaced complete | |
| 4 | Install in reverse sequence | Use exhaust pipe clamp (7/2) |