Performing Repair Work

Prior to starting body repair work, such as rear axle work, shock absorber work, spring work, or lifting vehicle onto a body straightening bench, extend roll-over bar and disconnect and shield negative battery cable. Additionally disconnect and remove both rear axle switches.

After performing repair work on roll-over bar, adjustment of roll-over bar is necessary. See ADJUSTMENTS  . Verify proper operation of roll-over bar. See ROLL BAR CRASH DEPLOYMENT SYSTEM FUNCTION TEST (SECTION 19.2/11.1)  under TROUBLE SHOOTING.

Repair Work After Accidents -  After an accident, it is necessary to replace system components under the following conditions:

• Defect in control module.
• Deformation or damage to control module or rear axle switches.
• Defect identified during testing.
• Damage to roll-over bar covering or foam padding beneath or support and actuating components.
• Convenience feature does not function.
• Malfunction indicator light does not go out.