Excessive Creep
EXCESSIVE CREEP (NJ8A(X)-EC/NN8A(X)-EC/MM8A(X)-EC) DESCRIPTION AND POSSIBLE CAUSE
| Description |
- Vehicle accelerates in D and R position when accelerator pedal is not depressed.
|
| Possible cause |
- Initial learning is not completed. (See INITIAL LEARNING [MM8AX-EC]
.)
- Input signal malfunction in the following. (See PID/DATA MONITOR INSPECTION
.)
PCM:
Electrically controlled brake unit/DSC HU/CM:
- Automatic transmission malfunction (automatic transmission internal parts malfunction) (Refer to [AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION
]
).
|
| System wiring diagram |
|