DTC P081C-00: Parking Lock Is Stuck (Parking Locked Status)

System malfunction location	Parking lock is stuck (parking locked status)
Detection condition	Parking lock cannot be released for a continuous period of time even though the parking lock is released.
Fail-safe	Not applicable
Possible cause	TCM stores following DTCs. P27F4-00: (Parking lock solenoid valve: Stuck off) (See P27F4-00: [TCM (NJ8A (X)- EC/NN8A (X)-EC/MM8A (X)-EC)] .) P0756-00: (ON/OFF solenoid valve No. 2: Stuck off) (See P0756-00: [TCM (NJ8A (X)- EC/NN8A (X)-EC/MM8A (X)-EC)] .) P07B6-00: (Parking position sensor: Stuck on) (See P07B6-00: [TCM (NJ8A (X)- EC/NN8A (X)-EC/MM8A (X)-EC)] .) PCM detects the DTC that the engine cannot started. (See DTC TABLE [PCM (PYUL)] .) DTC TABLE [PCM (H3T)] (See DTC TABLE [PCM (H3T)] .) If the engine cannot be started. (With Mazda M Hybrid boost) (See SYMPTOM TROUBLESHOOTING [T3] .) (See SYMPTOM TROUBLESHOOTING [H3T] .) Mazda M Hybrid Boost battery state of charge (SOC) is lower. (With Mazda M Hybrid boost) Malfunction in the following automatic transmission component parts (Refer to [AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION ] in service information). Parking lock mechanism
Repeatability verification procedure	Clear the DTC recorded in the memory. (See CLEARING DTC .) Perform the following procedure to ensure that the DTC has been resolved: Drive the vehicle. (selector lever at D or R position)
System wiring diagram	Not applicable