Remove Insulator (Front No. 1): Notes

WARNING: This page is about a different variant/trim than selected.

Fig 1: Front No. 1 Insulator, Bolts And Nuts With Torque Specification

Courtesy of MAZDA MOTORS CORP.

TIGHTENING TORQUE SPECIFICATION

Step	Part name
1	Nut (See Nut and bolt installation note )	9.5 N.m {95 kgf.cm, 82 in.lb}
2	Bolt (See Nut and bolt installation note )	9.5 N.m {95 kgf.cm, 82 in.lb}
3	Insulator (front No. 1) (See INSULATOR (FRONT NO. 1) INSTALLATION NOTE )	-