Remove Fuel-Filler Pipe: Notes
WARNING: This page is about a different variant/trim than selected.
- Remove in the order indicated in the table.
Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONSStep Part name 1 Bolt
(See BOLT, NUT INSTALLATION NOTE )11 N.m {110 kgf.cm, 95 in.lbf} 2 Joint hose - 3 Bolt
(See BOLT, NUT INSTALLATION NOTE )11 N.m {110 kgf.cm, 95 in.lbf} 4 Nut
(See BOLT, NUT INSTALLATION NOTE )11 N.m {110 kgf.cm, 95 in.lbf} 5 Fuel-filler pipe component - 6 Protector - 7 Protector - 8 Nut 11 N.m {110 kgf.cm, 95 in.lbf} 9 Protector - 10 Fuel-filler pipe -