PID/data monitor inspection
WARNING: This page is about a different variant/trim than selected.
- Using the M-MDS, display the instrument cluster PID [I-STOP_OFF_SW]. (Refer to [PID/DATA MONITOR TABLE (PYUL) ] in the appropriate troubleshooting information )
PID/DATA MONITOR
| Condition | Data content |
|---|---|
| [I-STOP_OFF_SW] | |
| i-stop OFF switch is pressed | On |
| Other than above | Off |
- If it cannot be verified as indicated in the table, replace cluster switch No. 1. (See CLUSTER SWITCH NO. 1 REMOVAL/INSTALLATION )