DTC inspection
WARNING: This page is about a different variant/trim than selected.
- Using the M-MDS, perform a DTC inspection and verify if any i-stop OFF switch-related DTCs are detected. (Refer to [PID/DATA MONITOR INSPECTION
] in the appropriate troubleshooting information
)
DTC is detected:
- Inspect the possible causes of the detected DTCs starting from the top. (Refer to [DTC TABLE [BCM]
] in the appropriate troubleshooting information
)
- If the malfunction is not resolved, replace cluster switch No. 1. (See CLUSTER SWITCH NO. 1 REMOVAL/INSTALLATION )
No DTC is detected
- Perform a PID/data monitor inspection. (See PID/DATA MONITOR INSPECTION )
- Inspect the possible causes of the detected DTCs starting from the top. (Refer to [DTC TABLE [BCM]
] in the appropriate troubleshooting information
)