DTC inspection
WARNING: This page is about a different variant/trim than selected.
- Using the M-MDS, perform a DTC inspection and verify if any fuel vapor temperature sensor-related DTCs are detected. (Refer to [DTC INSPECTION
] in the Troubleshooting Service Information)
DTC is detected
- Inspect for possible causes of detected DTCs in the order from the top. (Refer to [DTC TABLE [ECM]
] in the Troubleshooting Service Information)
- If the malfunction is not resolved, replace the fuel vapor temperature sensor. (See FUEL VAPOR TEMPERATURE SENSOR REMOVAL/INSTALLATION [PYUL] ).
No DTC is detected
- The fuel vapor temperature sensor is normal, therefore the inspection is completed.
- Inspect for possible causes of detected DTCs in the order from the top. (Refer to [DTC TABLE [ECM]
] in the Troubleshooting Service Information)