DTC inspection
WARNING: This page is about a different variant/trim than selected.
- Using the M-MDS, perform a DTC inspection and verify if any current sensor-related DTC is detected. (Refer to [DTC INSPECTION
] in the Troubleshooting Service Information)
DTC is detected
- Inspect for possible causes of detected DTCs in the order from the top. (Refer to [DTC TABLE [PCM]
] in the Troubleshooting Service Information)
- If the malfunction is not resolved, replace the current sensor. (See CURRENT SENSOR REMOVAL/INSTALLATION [PYUL] ).
No DTC is detected
- Perform a visual inspection. (See VISUAL INSPECTION )
- Inspect for possible causes of detected DTCs in the order from the top. (Refer to [DTC TABLE [PCM]
] in the Troubleshooting Service Information)