Remove Passenger Side Strut Tower Bar
WARNING: This page is about a different variant/trim than selected.
- Remove using the procedure shown in the figure below.
- the figure below shows the right side (same as left side).
Fig 1: Passenger Side Strut Tower Bar, Wiring Harness Clip, Connector, Bolts And Nuts With Torque Specification
TIGHTENING TORQUE SPECIFICATION
| Step | Part name | Applicable condition | |
|---|---|---|---|
| 1 | Connector | With windshield wiper de-icer | - |
| 2 | Wiring harness clip (See Wiring harness clip removal note ). |
- | - |
| 3 | Bolt | - | 35 N.m {3.55 kgf.m, 25.8 ft.lb} |
| 4 | Nut | - | 35 N.m {3.55 kgf.m, 25.8 ft.lb} |
| 5 | Strut tower bar | - | - |