Remove Crankshaft Pulley: Notes
WARNING: This page is about a different variant/trim than selected.
- Remove using the procedure shown in the figure below.
TIGHTENING TORQUE SPECIFICATIONS
| Procedure | Part name | ||
|---|---|---|---|
| 1 | Crankshaft pulley lock bolt (See CRANKSHAFT PULLEY LOCK BOLT REMOVAL NOTE ) (See CRANKSHAFT PULLEY LOCK BOLT INSTALLATION NOTE ) |
49 B011 105 205-072 (component part or 49 UN20 5072) | 110 N.m {11.2 kgf.m, 81.15 ft.lb} +55-65° |
| 2 | Crankshaft pulley | - | - |